Grundig Satellit 205

Manufactured by Grundig, Fürth.

The German radio manufacturer Grundig presented its first real world band receiver in 1964. The Satellit 205, a portable single conversion receiver, was the first set in Grundig's successful series of world band receivers, which came to an end in 1996 with the Satellit 700.

The receiver was produced in a version covering the shortwave broadcast bands and another covering the amateur radio bands.


Satellit 205Basic model with spread shortwave broadcast bandsTransistor AC151r in the AF preamplifier14-3080-1141/62
Transistor 5000Export model for the non-European market, shortwave bands marked S1-S10 instead of K1-K10, station names missing on medium waveTransistor AC151r in LF preamplifier14-3080-9141/62
Satellit 205 Amateuridentical model with spread amateur radio bands instead of shortwave broadcast bandsTransistor AC151r in the HF preamplifier
Satellit 205aSuccessor model from 1967, two rear panel screws and two screws on both sides of the window of the drum tunerTransistor BC108A or BSY76b in the LF preamplifier14-3080-1341/62
Transistor 5000aSuccessor model from 1967, two back panel screws and two screws on both sides of the window of the drum tunerTransistor BC108A or BSY76b in the NF preamplifier14-3080-9241/62

Satellite 205

Technical data

Power supply


  • 410 x 250 x 120 mm, weight 7 kg


Satellite 205: power supply

  • optional built-in mains adapter TN12
  • optional built-in BFO for single sideband reception

Satellite 205


As one of the earliest portable shortwave receivers, the Grundig Satellit 205 was introduced in 1964 as the forefather of a large family of „Satellit“ receivers. At the same time, the first fully transistorised Zenith trans-oceanic receiver, also equipped with a turret tuner for band spreading, from U.S. production was presented.

The Grundig Satellite 205, its international designation is Transistor 5000, had the dimensions of 41 x 25 x 12 cm and a weight of 7 kg. The separate power supply could be stored inside the set, which could alternatively be operated from batteries.

Satellite 205 The dial for the FM broadcast band, mediumwaves and the four general coverage shortwave bands from 180 - 10 m, is mounted on the right-hand side of the front panel, the row of range selector buttons next to it.

The FM tuning knob is located between the dial and the speaker grill. The small on/off switch is located immediately below it, followed by the tiny field strength meter calibrated from 1 - 5, right next to it the AFC switch for FM. Below the small shortwave fine tuning knob is the main MW/SW tuning knob.

The large loudspeaker is located at the left, behind a shiny grill. Above it, the window of the turret tuner with the bandspread dial of the selected shortwave broadcast band (49 - 16m), the bandswitch for the 6 ranges is located on the left face of the case. The volume control and the separate bass and treble tone controls are located on the top edge of the radio under the carrying handle.

The single conversion design allows reception of the major international shortwave broadcasters; with only one available IF bandwidth, adjacent stations often cannot be separated sufficiently. The frequency dial has an accuracy of 10 - 20 kHz in the spread broadcast bands, in the general coverage ranges the currently set frequency can only be estimated very roughly, for station identification interval signals and spoken station identification must be used, the dial accuracy is not sufficient to reliably find a station once tuned again at a later moment. SSB reception is only possible with the optionally available external BFO, with compromises in terms of frequency stability.

Considering the conditions in the mid-60s, the Satellit 205 was a serious portable world band receiver with great audio quality, which was capable to receive the signals of the stronger international broadcasters from its telescopic antenna possible, even when travelling.

The Satellit 205 Amateur was produced in a small number, this set tuned the spread amateur radio bands with the turret tuner instead of the international broadcast bands.

There are different versions: Export versions for export to English-speaking countries have designations „S5-S10“ for the spread shortwave bands, and the mediumwaves station names are not listed.

Technical principle

Single conversion superhet in analogue technology, spread SW broadcast bands with drum tuner


The set is equipped with semiconductors.

Technical documentation


Further information

en/satellit_205.txt · Zuletzt geändert: 2021/05/02 11:39 von mb